The Simcenter Amesim Run working modes

With Simcenter Amesim Run, you can set up the parameters of the submodels and then launch a simulation. Each step is performed in a specific working mode in Simcenter Amesim Run.

This section introduces the very basic features available in the working modes of Simcenter Amesim Run for new users.

Parameter mode

In Parameter mode, you can:

• Parameter mode change submodel parameters

examine and change submodel parameters,

• Parameter mode copy submodel parameters

copy submodel parameters,

• Parameter mode set global parameters

set global parameters,

• Parameter mode common parameters

select an area of the sketch and show common parameters in this area,

• Parameter mode specify a batch run

specify a batch run.

To be suitable for Simcenter Amesim Run, a .ame file must contain an executable file. This executable file makes the simulation possible. Normally before you perform a run you adjust the parameters of the model.

Note

You can display variable lists and plot results in Parameter mode through the Variable pane.

Simulation mode

In Simulation mode, you can:

• Simulation mode initiate standard and batch simulation runs

initiate standard and batch simulation runs,

• Simulation mode create plots of results

create plots of results,

• Simulation mode store and load the configuration

store and load the configuration of all or some of your plots,

• Simulation mode initiate linearizations

initiate linearizations of the current system,

• Simulation mode analyses of the linearized systems

perform various analyses on the linearized systems,

• perform Activity Index analysis.

Note

It is also possible to change parameters in Simulation mode through the contextual Parameters window.