Populate model parameters

Once all your measurements are done, you can now copy them and paste them to the Simcenter Amesim submodels parameters.

Procedure

1. Click Measure mode  to make the Measure mode active.

2. Select the first line of the measures.

3. Right-click the line and select Copy measurements.

Figure 39: Copy measurements

4. Make sure you are in a mode that gives you access to parameters in Simcenter Amesim and select the extreme right mass submodel.

Figure 40: Thermal mass submodel selection

5. Right-click the corresponding line of the parameter and choose Paste in the contextual menu.

Figure 41: Paste measurement value to parameter value

Figure 42: Mass value pasted

6. Repeat the operation for the other parameters listed above.

Note When you paste a measurement, the unit of the submodel parameter is also changed according to the units system defined in CAD Import.

Regarding the parameter distance between the two temperature points, you can set an expression of several pasted measurement values.

Figure 43: Expression of CAD measurements

Results

Note

The Copy/Paste measurements capability is also available for Global Parameters.